You will have to remove all wall panels or flooring to apply the ArmorGuard coating directly to the foundation to ensure a permanent bond.

NO, our coatings have no effect with negative pressure (water pushing from the outside in).

NO, actually the opposite is true. Concrete needs and thrives on moisture and every foundation has moisture, concrete without water is Portland cement and dirt. Look at any bridge piling, above the water the piling is degraded, under the water it is fine. You will read ads that claim that you have to dig up foundations from the outside and install the latest and greatest wall covering to prevent the wall from getting wet. This is just hype to get you to use their product. All dirt is moist…and all foundations are moist…PERIOD.

YES, ArmorGuard was developed after our pool and tank coatings, if we can keep water in a pool or tank, we can keep water out of your basement.

YES, ArmorGuard had been proven to reduce radon levels almost 50% by just coating the floor.

ArmorGuard has much less odors than regular latex house paint.

Use our ArmorGuard Trowel Mix to fill in cracks, holes or degraded areas, then clean and coat.

YES, ArmorGuard Basement Coatings will adhere to any substrate. For stone walls; fill in all areas with a concrete mortar mix first, then clean and coat. For Brick, block or concrete, fill any cracks or holes with our Trowel Mix, then clean and coat.

YES and NO, for minor water problems you can coat just those areas of concern and that may solve your problem, however, be aware the water may move to another area. It's always best to coat the entire area to prevent any future problems from existing.

ArmorGuard leaves a monolithic shell throughout the basement floor and walls. ArmorGuard is hurricane and flood tested, and does not require digging on the inside or outside to install. Our process works, GUARANTEED!

Yes, ArmorGuard can Coat over any existing surface leaving an almost maintenance free pool.

YES, if it was painted with an epoxy paint, if you have latex or water-based paint on pool you will need to sandblast, power wash, or scrap the old coating off.

YES, ArmorGuard is chemical, stain resistant and is exclusive to microban ; a built in hard surface anti-microbial that will resist the growth of algae or fungi saving you approx 50% on chemical usage per year. ArmorGuard coatings insulate, keeping your pool 40% warmer and are smooth to prevent resistance meaning you can run your pool less saving you on energy costs.

NO, with ArmorGuard Underwater Repair System, We can permanently repair any crack/hole without the need to drain.

There are also many colors to choose from, or you can choose a speckle flake finish.

No. ArmorGuard underwater leak system permanently fixes any cracks/damage without draining the pool or tank.

About 36 to 48 hours.

ArmorGuard is a permanent coating and can be made slip resistant by adding quartz, silica sand or pumice to the top coat before application or casting after application.

ArmorGuard will adhere to any surface (wood, block, stone, tile, concrete, steel, fiberglass), when surface preparation is complete.

With our FRP (Fiberglass Reinforced Polymer) process, ArmorGuard is almost indestructible, and will not crack...even with heavy machinery or impact.

ArmorGuard is chemical and stain resistant. Our industrial grade coating will withstand up to 98% pure sulfuric acid and many other toxic chemicals, please read the physical data sheets for more info.

Only 24 hours!

ArmorGuard is water tight. Standing water will not matter!

No. ArmorGuard products are odorless, non-toxic and safe.

Yes, you can add an additional coat, before applying the second coat, scuff first coat with a 36 grit sand paper with a palm sander, then apply the second coat. This will ensure a permanent bond.